30-Minute Rescue™ Cleaning Solution 8oz (Wet Cap) for Epson Printheads

30-Minute Rescue™ is a specially formulated cleaning solution designed for wet capping and helping restore missing Epson nozzles as quickly as possible. When heated and applied correctly, it works to soften and dissolve dried ink underneath the printhead, improving the chances of recovering clogged nozzles—often within just 30 minutes. While not a 100% guarantee, our 7-day test results showed consistent improvement and successful nozzle recovery in most cases.

How to Use
● Heat the solution (warm, NOT boiling).
● Apply 2–4 ml directly into the capping station using a syringe.
● Move the printhead into the capping position and let it sit for 30 minutes.
● After 30 minutes, run 1–2 cleaning cycles or perform a nozzle check.
● Repeat once if necessary.

Daily Maintenance Tip
Use 30-Minute Rescue™ only when needed, such as during printing or whenever you experience missing nozzles.
This solution is NOT meant to stay in the printer overnight. It is a short-term recovery soak used to help bring nozzles back quickly.

For overnight protection, always use your regular Moisturizing / Wet-Cap Solution, not this product.

PRO TIP
This solution must be heated to work effectively. Cold solution will not dissolve buildup or restore nozzles properly. Warm solution activates the cleaning agents and helps break down dried ink faster.
WARNING: Avoid getting any electronics wet.

NOTES:
● This product is to clean and flush Epson printheads.
● Bottle sizes may vary.

More Cleaning Products

DTF Cleaning Solution (Cleaning & Flush)
Red Piezo Cleaning Solution (Vacation & Repair)